Abbree AR-518 programming software
Open WebCHIRPWebCHIRP programs the Abbree AR-518 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Abbree programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the AR-518
- 128 memory channels, numbered 1 to 128
- Channel names up to 6 characters
- Transmit power: High 2.0W, Low 0.5W
- Modes: FM, NFM
- Bands: 20–64 MHz, 108–136 MHz, 136–174 MHz, 174–400 MHz, 400–520 MHz, 520–660 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
How to program a Abbree AR-518
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Abbree AR-518 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Abbree AR-518?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Abbree CPS software?
No. WebCHIRP runs CHIRP's own Abbree AR-518 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Abbree AR-518 hold?
128, numbered 1 to 128 in the channel table.