AnyTone 5888UV programming software
Open WebCHIRPWebCHIRP programs the AnyTone 5888UV in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
AnyTone programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the 5888UV
- 758 memory channels, numbered 1 to 758
- Channel names up to 7 characters
- Transmit power: High 50W, Mid1 25W, Mid2 10W, Low 5.0W
- Modes: AM, FM, NFM
- Bands: 108–500 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
Can I update the firmware on the 5888UV?
The 5888UV has no firmware update: its firmware is written at the factory and is not replaceable in the field. AnyTone's download page lists programming software for this analog model, not firmware.
AnyTone downloads at anytone.net
WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.
How to program a AnyTone 5888UV
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check AnyTone 5888UV is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the AnyTone 5888UV?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the AnyTone CPS software?
No. WebCHIRP runs CHIRP's own AnyTone 5888UV driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the AnyTone 5888UV hold?
758, numbered 1 to 758 in the channel table.
Can I update the firmware on the AnyTone 5888UV?
The 5888UV has no firmware update: its firmware is written at the factory and is not replaceable in the field. AnyTone's download page lists programming software for this analog model, not firmware. WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.