Bajeton BJ7800 programming software
Open WebCHIRPWebCHIRP programs the Bajeton BJ7800 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Bajeton programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the BJ7800
- 960 memory channels, numbered 1 to 960
- Channel names up to 12 characters
- Transmit power: High 8.0W, Middle 4.0W, Low 1.0W
- Modes: AM, FM, NAM, NFM
- Bands: 18–1000 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
How to program a Bajeton BJ7800
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Bajeton BJ7800 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Bajeton BJ7800?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Bajeton CPS software?
No. WebCHIRP runs CHIRP's own Bajeton BJ7800 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Bajeton BJ7800 hold?
960, numbered 1 to 960 in the channel table.