Boblov X3Plus programming software
Open WebCHIRPWebCHIRP programs the Boblov X3Plus in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Boblov programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the X3Plus
- 16 memory channels, numbered 1 to 16
- Channel names up to 6 characters
- Transmit power: Low 0.5W, High 2.0W
- Modes: FM, NFM
- Bands: 400–470 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
How to program a Boblov X3Plus
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Boblov X3Plus is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Boblov X3Plus?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Boblov CPS software?
No. WebCHIRP runs CHIRP's own Boblov X3Plus driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Boblov X3Plus hold?
16, numbered 1 to 16 in the channel table.