Kenwood TM-D710G_CloneMode programming software
Open WebCHIRPWebCHIRP programs the Kenwood TM-D710G_CloneMode in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
Program my TM-D710G_CloneMode now
No driver install needed
Kenwood programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the TM-D710G_CloneMode
- 1000 memory channels, numbered 0 to 999
- Channel names up to 8 characters
- Modes: AM, FM, NFM
- Bands: 118–135.995 MHz, 136–199.995 MHz, 200–299.995 MHz, 300–399.995 MHz, 400–523.995 MHz, 800–1299.995 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
Can I update the firmware on the TM-D710G_CloneMode?
Kenwood publishes a firmware update for the TM-D710G_CloneMode that you can install yourself. There are two updaters: main and panel.
Firmware downloads at kenwood.com
WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.
How to program a Kenwood TM-D710G_CloneMode
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Kenwood TM-D710G_CloneMode is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Kenwood TM-D710G_CloneMode?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Kenwood CPS software?
No. WebCHIRP runs CHIRP's own Kenwood TM-D710G_CloneMode driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Kenwood TM-D710G_CloneMode hold?
1000, numbered 0 to 999 in the channel table.
Can I update the firmware on the Kenwood TM-D710G_CloneMode?
Kenwood publishes a firmware update for the TM-D710G_CloneMode that you can install yourself. There are two updaters: main and panel. WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.