Maverick RA-100 programming software
Open WebCHIRPWebCHIRP programs the Maverick RA-100 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Maverick programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the RA-100
- 16 memory channels, numbered 1 to 16
- Channel names up to 6 characters
- Transmit power: Low 1.0W, High 5.0W
- Modes: FM, NFM
- Bands: 400–490 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
How to program a Maverick RA-100
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Maverick RA-100 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Maverick RA-100?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Maverick CPS software?
No. WebCHIRP runs CHIRP's own Maverick RA-100 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Maverick RA-100 hold?
16, numbered 1 to 16 in the channel table.