Radioddity GA-510 programming software
Open WebCHIRPWebCHIRP programs the Radioddity GA-510 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Radioddity programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the GA-510
- 128 memory channels, numbered 0 to 127
- Channel names up to 10 characters
- Transmit power: H 10W, L 1.0W, M 5.0W
- Modes: FM, NFM
- Bands: 136–174 MHz, 400–480 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
Which GA-510 do you have?
CHIRP has 2 drivers for the Radioddity GA-510, covering different firmware and production runs. The figures above are the GA-510 (stock); open yours directly if it is one of the others.
- GA-510 (stock) — 128 channels, names up to 10 characters
- GA-510 (V2) — 128 channels, names up to 8 characters
Can I update the firmware on the GA-510?
Radioddity publishes firmware updates, though not for every radio it has made. Its download page is where to check whether the GA-510 is one of them. Its firmware downloads cover the DMR radios; much of the analog range has programming software only.
Firmware downloads at radioddity.com
WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.
How to program a Radioddity GA-510
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Radioddity GA-510 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Radioddity GA-510?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Radioddity CPS software?
No. WebCHIRP runs CHIRP's own Radioddity GA-510 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Radioddity GA-510 hold?
128, numbered 0 to 127 in the channel table.
Can I update the firmware on the Radioddity GA-510?
Radioddity publishes firmware updates, though not for every radio it has made. Its download page is where to check whether the GA-510 is one of them. Its firmware downloads cover the DMR radios; much of the analog range has programming software only. WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.