Radioddity GM-30 Plus programming software
Open WebCHIRPWebCHIRP programs the Radioddity GM-30 Plus in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Radioddity programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the GM-30 Plus
- 1000 memory channels, numbered 1 to 1000
- Channel names up to 12 characters
- Transmit power: High 5.0W, Low 1.0W
- Modes: AM, FM, NFM
- Bands: 108–136 MHz, 136–174 MHz, 200–260 MHz, 400–520 MHz, 350–390 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
Can I update the firmware on the GM-30 Plus?
Radioddity publishes firmware updates, though not for every radio it has made. Its download page is where to check whether the GM-30 Plus is one of them. Its firmware downloads cover the DMR radios; much of the analog range has programming software only.
Firmware downloads at radioddity.com
WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.
How to program a Radioddity GM-30 Plus
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Radioddity GM-30 Plus is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Radioddity GM-30 Plus?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Radioddity CPS software?
No. WebCHIRP runs CHIRP's own Radioddity GM-30 Plus driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Radioddity GM-30 Plus hold?
1000, numbered 1 to 1000 in the channel table.
Can I update the firmware on the Radioddity GM-30 Plus?
Radioddity publishes firmware updates, though not for every radio it has made. Its download page is where to check whether the GM-30 Plus is one of them. Its firmware downloads cover the DMR radios; much of the analog range has programming software only. WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.