WLN KD-C1 programming software

WebCHIRP programs the WLN KD-C1 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.

Program my KD-C1 now

No driver install needed

WLN programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.

What you can edit on the KD-C1

• 16 memory channels, numbered 1 to 16
• Channel names up to 6 characters
• Transmit power: Low 2.0W, High 5.0W
• Modes: FM, NFM
• Bands: 400–520 MHz
• Tone squelch: Cross, DTCS, TSQL, Tone
• Radio-wide settings, not just the channel list

How to program a WLN KD-C1

1. Plug the programming cable into the radio and the computer.
2. Open WebCHIRP, check WLN KD-C1 is selected, and press Download.
3. Edit the channels, or pull in nearby repeaters from a directory.
4. Press Upload to write the result back to the radio.

Questions

Do I need to install a USB driver to program the WLN KD-C1?

No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.

Do I need the WLN CPS software?

No. WebCHIRP runs CHIRP's own WLN KD-C1 driver in the browser, so it reads and writes the same codeplug the desktop software does.

How many channels does the WLN KD-C1 hold?

16, numbered 1 to 16 in the channel table.

All supported radios