Yaesu FT-7100M programming software
Open WebCHIRPWebCHIRP programs the Yaesu FT-7100M in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Yaesu programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the FT-7100M
- 241 memory channels, numbered 0 to 240
- Channel names up to 6 characters
- Transmit power: Low 5.0W, Low2 10W, Low3 20W, High 35W
- Modes: AM, FM
- Bands: 108–180 MHz, 320–999.99 MHz
- Tone squelch: DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
How to program a Yaesu FT-7100M
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Yaesu FT-7100M is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Yaesu FT-7100M?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Yaesu CPS software?
No. WebCHIRP runs CHIRP's own Yaesu FT-7100M driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Yaesu FT-7100M hold?
241, numbered 0 to 240 in the channel table.