Yaesu FTM-7250D programming software
Open WebCHIRPWebCHIRP programs the Yaesu FTM-7250D in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Yaesu programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the FTM-7250D
- 199 memory channels, numbered 1 to 199
- Channel names up to 8 characters
- Transmit power: Low 5.0W, Mid 25W, Hi 50W
- Modes: FM, NFM
- Bands: 108–580 MHz
- Tone squelch: Cross, DTCS, Pager, TSQL, TSQL-R, Tone
Can I update the firmware on the FTM-7250D?
The FTM-7250D has no firmware update: its firmware is written at the factory and is not replaceable in the field.
WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.
How to program a Yaesu FTM-7250D
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Yaesu FTM-7250D is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Yaesu FTM-7250D?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Yaesu CPS software?
No. WebCHIRP runs CHIRP's own Yaesu FTM-7250D driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Yaesu FTM-7250D hold?
199, numbered 1 to 199 in the channel table.
Can I update the firmware on the Yaesu FTM-7250D?
The FTM-7250D has no firmware update: its firmware is written at the factory and is not replaceable in the field. WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.