Yedro YC-M04VUS programming software

WebCHIRP programs the Yedro YC-M04VUS in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.

Program my YC-M04VUS now

No driver install needed

Yedro programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.

What you can edit on the YC-M04VUS

• 200 memory channels, numbered 1 to 200
• Channel names up to 5 characters
• Transmit power: Low 5.0W, Medium 10W, High 25W
• Modes: FM, NFM
• Bands: 136–174 MHz, 400–490 MHz
• Tone squelch: Cross, DTCS, TSQL, Tone
• Radio-wide settings, not just the channel list

How to program a Yedro YC-M04VUS

1. Plug the programming cable into the radio and the computer.
2. Open WebCHIRP, check Yedro YC-M04VUS is selected, and press Download.
3. Edit the channels, or pull in nearby repeaters from a directory.
4. Press Upload to write the result back to the radio.

Questions

Do I need to install a USB driver to program the Yedro YC-M04VUS?

No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.

Do I need the Yedro CPS software?

No. WebCHIRP runs CHIRP's own Yedro YC-M04VUS driver in the browser, so it reads and writes the same codeplug the desktop software does.

How many channels does the Yedro YC-M04VUS hold?

200, numbered 1 to 200 in the channel table.

All supported radios