KYD IP-620 programming software
Open WebCHIRPWebCHIRP programs the KYD IP-620 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
KYD programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the IP-620
- 200 memory channels, numbered 1 to 200
- Channel names up to 6 characters
- Transmit power: Low 1.0W, Medium 2.5W, High 5.0W
- Modes: FM, NFM
- Bands: 136–174 MHz, 200–260 MHz, 300–340 MHz, 350–390 MHz, 400–480 MHz, 420–510 MHz, 450–520 MHz
- Tone squelch: DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
How to program a KYD IP-620
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check KYD IP-620 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the KYD IP-620?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the KYD CPS software?
No. WebCHIRP runs CHIRP's own KYD IP-620 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the KYD IP-620 hold?
200, numbered 1 to 200 in the channel table.