KYD NC-630A programming software
Open WebCHIRPWebCHIRP programs the KYD NC-630A in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
KYD programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the NC-630A
- 16 memory channels, numbered 1 to 16
- Channel names up to 6 characters
- Transmit power: Low 1.0W, High 5.0W
- Modes: FM, NFM
- Bands: 400–520 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
Also sold as
The same CHIRP driver covers these rebadges, so this page applies to them too: Plant-Tours MT-700.
How to program a KYD NC-630A
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check KYD NC-630A is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the KYD NC-630A?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the KYD CPS software?
No. WebCHIRP runs CHIRP's own KYD NC-630A driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the KYD NC-630A hold?
16, numbered 1 to 16 in the channel table.